In this video you will get information on the solutions we offer to optimise each of the following maintenance tasks usually carried out in a wheel shop.

Wheelset maintenance usually starts with a bearing and end cap disassembly area. Next, there is an inspection and diagnosis phase that…

There are many elements that go into building a truly accurate machine tool, and one that will maintain its accuracy over time.

There are a number of add-ons that can improve accuracy, but none can compensate for a design that is structurally unsound. It all starts with the base, one of…

Deciding whether to finish a part with grinding or hard turning is difficult and often counterintuitive. Both can achieve extremely high tolerances and surface finishes.

It would be nice if there were a clear set of standards to determine whether a part should be hard turned or ground.…